Различия

Показаны различия между двумя версиями страницы.

--- 4amps:1tu:ccs [2022/01/21 12:37]
staudio [Усилитель на 300B]
+++ 4amps:1tu:ccs [2022/01/21 12:43]
staudio [Усилитель на 47 пентодах]
@@ Строка 370: / Строка 370: @@
 {{4amps:1tu:47pp_under.jpg}}
+==== "Каменный" вариант ====
+http://www.pimmlabs.com/web/solid_state.htm\\
+Quite awhile back I got an email from John Swenson asking if the active circuitry used in the self bias could be used as an amplifier. I mentioned that I thought it would work and in fact had thought of the ideas several times in the past but had never pursued the idea. John went on to do experiments and came up with several interesting tranconductance amplifier ideas.
+After hearing of his successes I decided to try some ideas of my own. One of the early experiments was to compare a single IRF820b MOSFET to a modified self bias CCS amplifier. I started calling the basic building block the Solid State Pentode based on the way the circuit works.
+While the characteristic curves of single MOSFETs looks very Pentode like they do not have the low input capacitance of a Pentode. The cascode circuit below acts very much like an ideal Pentode as the gate to source capacitance of the upper MOSFET is shunted to the source of the lower MOSFET via C5.
+Here is the schematic of the basic SSP building block.
+{{4amps:1tu:ss_pentode.gif}}
+The next experiment was a CCS loaded differential stage. This stage is a tranconductance amplifier, meaning that an input voltage is converted to an output current. The goal was building a solid state version of the Tabor amplifier with an interstage transformer between the input and output stage. I was using 6.6K as the load for the input stage as this is what the estimated input impedance of the Tabor output stage. Later I substituted a 6.6K output transformer and found that by increasing the operating current and B+ voltage the single stage could deliver 10W into 8 ohms at quite low distortion. Not bad for a single stage amplifier. The output impedance is very high. With the amplifier delivering 10V rms into 8 ohms I clipped a second 8 ohm load resistor in parallel dropping the load impedance to 4 ohms. The output voltage dropped to 5V rms.
+Here is the schematic of the input tranconductance stage with values for both input stage and tranconductance output stage amplifier uses.
+{{4amps:1tu:differential_tranconductance.gif}}
+After the success of the input stage I wanted to mate it to the output stage and see the results. Here is the schematic of the first prototype of the "Solid State Tabor".
+{{4amps:1tu:ss_dif_poweramp.gif}}
+{{4amps:1tu:ss_amp.jpg}}

Аудио-википедия

Инструменты пользователя

Инструменты сайта

Различия

Инструменты страницы